answer 1
Remove the spray nozzle and soak it in hot water for a few minutes
answered 2 years, 2 months ago
answer 2
Run the top under warm water for about 30 seconds... usually does the trick. Then just shake it before your next use!
answered 2 years, 3 months ago
answer 3
Sephora replaced mine when it got clogged.
answered 2 years, 4 months ago
sfdesigner
(San Francisco, CA)
answer 4
To Prevent Clogging:
-Shake can vigorously prior to and during each usage; if this is not done, solids that fall to the bottom of the can travel through the tube and clog the valve.
-Immediately following each use, rotate the actuator (nozzle) between your thumb and forefinger 8 to 10 full revolutions; this action should remove any powder left on the valve.
-If the product becomes clogged or does not spray, take off the actuator (nozzle) and clean it with a cotton swab dipped in rubbing alcohol; dry well and place nozzle back on the stem.
answered 2 years, 6 months ago
answer 5
SOAK IT IN HOT WATER FOR 10 MINS
answer 6
This product will have an “empty” feel as the product consists of powder, alcohol, and gas. For best results, shake the can well prior to and during use to ensure the product is properly mixed and prevent the powder from clogging the valve. If the valve is clogged, take off the nozzle and wash it with hot water. After drying well, place nozzle back on the stem, shake the can and depress the nozzle upside-down. If it sprays it means the valve is not clogged, if it does not spray the valve is still clogged. If this does not work, try squeezing the can – if it collapses easily, there is no gas in the can. Again, shaking before and during use will ensure the product is properly mixed for best use.
answered 4 years, 8 months ago
BelleDeJour
(San Francisco, CA)